BPC PowerMaster Manual do Proprietário descarregar pdf (Página 7)

Connecting your LEGACY PowerMaster to a FasTrack terminal section

Figure 4. Transformer connections

FasTrack terminal section

Notch

Spade-shaped

connector

f you are using the Lionel FasTrack track system, you will find that the terminal section

easily connects to thePowerMaster's output terminals. Two wires are attached to the

underside of the FasTrack terminal section (available separately, 6-12016). Attach the spade-

shaped connectors at the ends of these wires to the PowerMaster. Be sure that the connections

are secure. Follow these steps and refer to Figure 4.

If you are connecting the PowerMaster to your layout with any other type of wire,

refer to the guidelines on page 5.

1. Feed the wires through the notch in the FasTrack terminal section. Refer to

Figure 4.

2. Loosen the “A” thumbscrew terminal, then slide the spade-shaped

connector with the RED insulation at the end of the black wire with white

tracer into position. The thumbscrew post should be positioned between the “blades”

of the spade connector. Tighten the thumbscrew to secure the connection.

3. Loosen the “U” thumbscrew terminal, then slide the spade-shaped

connector with the BLACK insulation at the end of the black wire into

position. Tighten the thumbscrew to secure the connection.

Caution!

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Sem comentários

BPC PowerMaster Manual do Proprietário Página 7