BPC PowerMaster Manual do Proprietário descarregar pdf (Página 22)

Controlling Tracks wired to the BPC2

o address your switch, press TR or ACC and the TMCC ID# of the block on the CAB remote

controller. Be sure to enter the specific ID# corresponding to the BPC2 terminals to which

the block is wired.

Once you've addressed a track power block, it can be operated using the AUX1 and AUX2

keys on your remote.

To turn track power on:

Press the AUX1 button on your CAB remote controller.

To turn track power off:

Press the AUX2 button on your CAB remote controller.

Finding the correct ID for each of the BPC2's Blocks.

If a block does not operate as expected, it may be that you have not addressed it by the

rightTMCCID#.RecallthateachBPC2hasabaseaddressthatyoumustassign(seepage

15).UsethebaseaddresstodeterminethespecificTMCCID#ofeachofuptofourconnected

switches. Switch 1's ID is the same as the base address. Switch 2's ID is the base address plus 1.

For example, assume your BPC2 has a TMCC base address of "1." If you would like to

operatetheblockwiredtothethirdterminalofanBPC2unit,youneedtopressTR(orACC),

3 on your CAB remote controller. Then operate that switch using AUX1 or AUX2.

If your BPC2 had a different base address, for example 17, then the address of the third

switch would be 19. In this case, you'd press TR, 1, then 9 on your CAB remote controller.

Then control power to that block using AUX1 and AUX2.

The BPC2's LED illuminates for one half of a second to indicate that it has received

a command.

1 2 ... 17 18 19 20 21 22 23 24

Sem comentários

BPC PowerMaster Manual do Proprietário Página 22